Repairing the sealing machine is not that simple, a professional team is needed!
Sealing machines may seem uncommon, but in fact, sealing machines are one of the most popular machines and equipment in packaging-related industries. And it often seems relatively simple. It seems that it only requires a certain amount of heat and pressure to achieve the purpose of sealing. But once such a simple device breaks down, it will be more troublesome to repair. Not long ago, Hong Kong Junhong Electrical Maintenance received a maintenance request for a Deli sealing machine. It’s a good time to talk about the failure of the sealing machine and the plan to repair the sealing machine.
One, it can’t be sealed
For sealing machines, no matter what brand, failure to seal or the sealing is not firm is a very serious problem. Once it cannot be sealed and it is easy to open, the internal products will be contaminated or damaged by the outside. For example, if it is food, you need to face the risk of high bacterial index or contamination. The solution needs to match the fault.
1. Temperature setting problem. If you find that the temperature setting is too low, preventing proper sealing, then adjusting the appropriate temperature is necessary.
2. Insufficient sealing time. Sometimes because the sealing time is too short, the heat has not had time to be transmitted and the materials have not merged with each other. So the time also needs to be adjusted.
3. Insufficient sealing pressure. Sealing requires pressing and sealing from top to bottom. If the pressure is not enough, this often cannot be achieved. So you can check whether the pressure setting is too low.
Second, the sealing machine does not work
Sometimes the sealing machine fails to operate after pressing the switch.
1. Check the power supply and wires to make sure the power supply is functioning properly. You can check whether the power supply is flowing normally by replacing the plug.
2. The control panel is faulty. If it still cannot be turned on after restarting, it is a problem with the control panel. Once there is a problem with the control panel, it needs to be replaced or repaired. This requires a professional maintenance team. The technicians at Hong Kong Junhong Electrical Maintenance can detect the problem immediately and carry out the following maintenance work.
3. The sealing machine makes too much noise
1. Insufficient lubricating oil. Several points of the sealing machine require lubrication before they can operate smoothly. Therefore lubricating oil is also a must.
2. Parts are loose or damaged. Sometimes some parts on the sealing machine become loose, which can also cause noise. Parts need to be purchased and installed again.
3. The placement is unstable and there is no sound insulation installation. Sometimes it is not placed in the correct position, causing the equipment to be unstable, and the chassis is not equipped with a sound insulation cover, which can cause noise problems. Therefore, they can be solved one by one.
The above are several aspects of repairing the sealing machine. Although the operating principle of the sealing machine is simple, you must remember that a professional maintenance team is also necessary.
Comments