Sharing the correct maintenance process of bone cutter

Sharing the correct maintenance process of bone cutter

Last month, Hong Kong Junhong Electrical Appliance Repair Center received a call from a restaurant owner. The owner's Bingsite bone cutter made abnormal noises and the cutting became uneven. After receiving the call, Hong Kong Junhong Electrical Appliance Repair Center immediately dispatched technicians to the door. . High-intensity equipment like bone cutters must pay attention to daily maintenance and cleaning, and also consider the replacement of consumables such as cutter heads. Next, we will take the Bingsite bone cutter as an example to talk about common faults and troubleshooting. and maintenance ideas.

1. Solutions to uneven cutting

After the technicians from Hong Kong Junhong Electrical Maintenance Center came to the door, they inspected the Bingsite bone cutter that had only been used for two years according to the boss's description. The specific maintenance process of the bone cutter is as follows:

(1) Confirm that the bone cutter has been completely powered off, and prepare necessary disassembly tools such as screwdrivers.

(2) Use a screwdriver to remove the protective cover, then remove the nut fixing the cutter head by turning counterclockwise, and then carefully check the cutter head. Usually cutting abnormalities are related to the wear of the cutter head, and this time Bingsite The bone cutter head is still relatively new and shows no significant wear.

(3) Polish the cutter head properly and wipe it, then check the guide rail behind the cutter head. There are a lot of bone fragments and minced meat on the guide rail of this Bingsite bone cutter, which causes the cutter head to deviate when moving. This requires deep cleaning.

(4) After cleaning, install the cutter head smoothly, confirm that the installation is correct, then power on and test run, and find that the problem has been completely solved. Because different bone cutters have slightly different structures, if we are unable to perform deep cleaning and maintenance ourselves, it is recommended to perform regular maintenance. Hire professionals to come and clean your home.

2. Solution to the problem of no response after the bone cutter is powered on

Hong Kong Junhong Electrical Appliance Repair Center has also encountered a situation where the bone cutter did not respond after being turned on. It was a heavy-armor bone cutter. Next, we will use this case to talk about how to repair the bone cutter when encountering the problem of no response. :

(1) First cut off the power of the bone cutter and then use professional tools to disassemble the casing. If you have encountered a power outage problem caused by the electrical load in the room, you must first check whether the fuse of the bone cutter is blown.

(2) After checking the fuse of the heavy armor bone cutting machine, it was found that there was no abnormality. Then I used a multimeter to measure the winding resistance of the unit. It was found that the resistance was infinite, indicating that the motor was burnt. In this case, try to replace it with the original model. The motor can run normally after replacement.

In fact, although equipment such as bone cutters are highly intensive, the overall structure is not complicated. Therefore, if you pay attention to cleaning and maintenance during daily use and avoid using more electricity than the load, there will basically be no malfunctions. However, if you encounter problems, you still have to entrust it to Professionals will come to your home to repair the bone cutter to prevent the fault from becoming serious.