Whirlpool Washing Machine Troubleshooting and Solutions!

Whirlpool Washing Machine Troubleshooting and Solutions!

Washing machines are one of the most common cleaning equipment. In fact, there are many different brands and models of washing machines now. Therefore, when encountering a fault, not all washing machines solve it in the same way. It is also very important to find a more professional maintenance team. In the industry of repairing electrical appliances, Hong Kong Junhong Electrical Repair is naturally the first choice. Today, they will understand and deal with various faults that occur in Whirlpool washing machines.

1. Solution to the problem of the washing machine not functioning properly

Sometimes when we turn on the washing machine, we will find that the washing machine cannot start. Sometimes there is no movement, simply the button cannot be activated. It is also possible that it makes a squeaking sound but does not start normally. If it is left to Hong Kong Junhong Electrical Maintenance to handle it, the specific method is as follows.

1. First check whether the power supply is stable. You can try to check by replacing the power strip first. If the power supply itself is unstable, you only need to replace the power supply to solve the problem. But if you find that the power supply is normal, you can check whether there is a problem with the control board.

2. The control board can be replaced or you can try to reset it. Of course, there may also be a problem with the motor. This is what we call a computer board failure. At this time, replacement is inevitable.

3. Finally, you can check the door lock problem. In fact, for the sake of safety, most washing machines now use a function that prevents the door from starting if the door lock is not tight. So often after opening the door and closing it tightly again, the washing machine can still operate normally.

2. Solution to poor drainage of washing machine

1. The general drainage function is controlled through an air pressure switch. You can open the back cover at the lower rear of the washing machine. There will be a rubber tube inside, which is connected to the water pipe below, and the interface air pressure switch above. If the air pressure switch has poor electrical contact, you need to directly disassemble and replace the air pressure switch. Hong Kong Junhong Electrical Maintenance Master will first check whether the air pressure switch is normal through a multimeter.

2. If the air pressure switch is normal, then it is basically certain that the problem is with the water pipe. At this time, you only need to unplug the rubber tube, and then check whether the rubber tube is damaged by inflating it. If it is a problem at both ends, you can directly cut off the damaged edges on both sides. If it is an intermediate problem, the rubber tube needs to be replaced.

The above are two common problems with washing machines. In addition, water quality will also affect the normal operation of the equipment. Therefore, it is recommended to perform regular maintenance on Whirlpool washing machines to reduce faults as much as possible.